LittleFoot Elegance Photo > LittleFoot Elegance Photo

LFEP down !

<< < (2/7) > >>

the_lizardking:
You made it more often than me  :P

Antoon:
Hi Armando and Lizardking,

Sorry i did'nt answered anymore yesterday, i had family on visit.
Armando thanks for bringing up the forum back.  :)

I am very sure that the switch is in the right position.(to the right). And the display stays on "display init..."
If i switch it to the left, then there is no display at all. It stays dark.
I also switched everything off. Just the power and the handpad are connected.
It stays the same.
The controller is here with me. So i can do some testing.
Will look at what Lizardking said about the firmware upgrade today.
But i must say, i am absolutely no software or pc specialist.
So i will look and study this carefully first before doiing some stupid things.  ;)

Thanks Guys for your answers, i will let you know.
Antoon

Armando:
Hi Antoon,


--- Quote from: Antoon on Sunday, 05.05.13 - 07:37:53 - CEST ---Armando thanks for bringing up the forum back.  :)
--- End quote ---
Thanks to Roman: he is the forum administrator.  ;)
Maybe the temporary forum off state occurs periodically because of maintenance and so no issue occurred.


--- Quote ---If i switch it to the left, then there is no display at all. It stays dark.
--- End quote ---
Maybe I was wrong!  :-[
Unfortunately just now I can't check: I always power my LFEP by a battery and a few hours ago I found my 12V battery at 9V (fully discharged - probably damaged too).


--- Quote ---Will look at what Lizardking said about the firmware upgrade today.
--- End quote ---
I would suggest to wait for a confirmation that the display should stay locked on "Display init.." with the switch on the left...
If it doesn't occur only on your LFEP unit then maybe the handbox cable is defective...

CS
Armando

Antoon:
Hi Armando,

Thanks for the answer. Ok i'll wait for confirmation.
Yesterday i opened the handpad plug to see if maybe a wire was off, but it seemed to be ok.
But maybe i can measure the cable point to point to see if there is any broken wire.
I'll try to do this today and let you know. But we have (again) :-\ some family visit. Sorry  :-\

Thanks and till later
Antoon

drknoppi:
Hello Antoon, i had a similar problem, i think the main problem is
A confused preference file . To solve this please reset the cu and videounit
With the help of ascom driver if can connect to LFEP . This problem is not new .
From time to time it was the same on my LFEP . Last attempt please load your FW again and the
LFEP will alive again 😀
I think how all another software the firmware of the LFEP have several bugs 😳.
That make it not so easy as i thinked at the start using LFEP 😥
Best regards
Rainer

Navigation

[0] Message Index

[#] Next page

[*] Previous page